Basement Waterproofing - Building Basement Walls

- 17.04

Basement waterproofing refers to techniques or materials used to reduce water penetrating the basement of a structure. Waterproofing systems seal the foundation against the entry of water. Waterproofing involves the application of materials and/or sealants and installation of drains and possibly a sump pump to collect, remove and/or redirect water away from the basement.

framing basement walls around ducts - Framing Basement Walls Tips ...
decoryourhouse.com



Purpose

Waterproofing is often required for structures built at or below ground level. Waterproofing and drainage considerations are especially important in cases where ground water is likely to build up in the soil and raise the water table. A higher water table causes hydrostatic pressure to be exerted underneath basement floors and against basement walls. Hydrostatic pressure forces water in through cracks in foundation walls, and through openings caused by expansion and contraction of the footing-foundation wall joint, or up through floor cracks. Hydrostatic pressure can cause major structural damage to foundation walls, and is likely to contribute to mold, decay, and other moisture-related problems.

Building Basement Walls Video




Methods

Several measures exist to prevent water penetrating a basement foundation; they do differ greatly in theory and design. The methods include:

  • placing interior wall and floor sealers
  • providing interior water drainage
  • including exterior drainage combined with waterproofing coatings
  • having sump pumps
  • increasing ventilation and air flow
Building A Wall In Basement - Home Decorating Design
www.senece.net


Interior sealants

In poured concrete foundations, cracks and pipe penetrations are the most common entry points for seepage. These openings can be readily sealed from the interior. Epoxies, which are strong adhesives, or urethanes are pressure injected into the openings, penetrating the foundation through to the exterior, thereby cutting off the path of the seepage. This repair approach provides a long term solution, with stability for 10 years or more.

In masonry foundations, interior sealers will not provide permanent protection from water infiltration where hydrostatic pressure is present. Interior sealers are good for preventing high atmospheric humidity inside the basement from absorbing into the porous masonry and causing spalling. Spalling is a condition where constant high humidity or moisture breaks down masonry surfaces, causing deterioration and shedding of the concrete surfaces.

When the foundation is constructed of concrete blocks, an interior drain tile system, described below, can capture the water entering the block system and drain the water into a sump. Typically, weep holes are drilled into the lowest course of block, allowing the drainage to occur. This system will provide a dry basement.

Interior sealants and systems should only be used for hydrostatic pressure and or areas where excavation is not possible. It is often not possible to protect a basement foundation without excavating and exposing foundation, restoring and sealing.

framing basement walls around ducts - Framing Basement Walls Tips ...
decoryourhouse.com


Interior water drainage

Although interior water drainage is not technically waterproofing, it is a widely accepted technique in mitigating basement water and is generally referred to as a basement waterproofing solution. Many interior drainage systems are patented and recognized by BOCA(Building Officials and Code Administrators) as being effective in controlling basement water. They function by draining underground water from alongside the foundation footers and underneath the basement floor. They then channel it with a French drain, PVC pipe, or through a patented product to a sump pump system, which will then pump the water from the basement. Wall conduits such as dimple boards or other membranes are fastened to the foundation wall and extend over the new drainage to guide any moisture down into the system. Foundation sump pumps can be installed through do-it-yourself kits, plumber installations, or by a professional waterproofing contractor and generally come in plastic and cast-iron models.

In summary:

  • Water enters the structure via the basement wall/floor joint, through cracks in the foundation walls and/or holes created by faulty or decaying masonry/brick.
  • A perimeter trench drain, such as a French drain, collects the water before it enters into the basement.
  • Wall vapor barriers/retarders and drip moldings are used and incorporated into the sub-slab perimeter drain to collect water coming from wall cracks and other foundation wall defects, such as pipe protrusions.
  • The drain directs the water to a sump pump.
  • The sump pump directs the water out of the structure.

Interior basement waterproofing systems should be prepared to work in the case of a power outage, the failure of a sump pump, and in the face of overwhelming torrential rain. A proper sump pump, backup sump and/or battery backup sump pump should be installed in a large sump pit with an airtight lid, for safety. A sump system also works to keep humidity from seeping through to the basement environment, where (humidity) can promote mold growth. This airtight practice will also reduce the possibility of dangerous radon gas entering the habitable space.

Framing Basement Walls | Decoration Ideas Blog
www.uploadarmy.com


Interior waterproofing

Interior basement waterproofing using coatings is effective where condensation is the main source of wetness. It is also effective if the problem is minor dampness. Usually, major leaks are unable to be solved by internal coatings. In such cases, if outside waterproofing has been ruled out, sheet or tile coverings which conceal drainage structures to carry the water out and drain it from the structure may be employed.

Internal drainage systems also include breaking a trench in the concrete floor along the perimeter walls. Weeping tiles are then installed in the trench and filled with 3/4" gravel. A waterproof dimple board is then installed on top extending up the foundation walls. The new weeping tiles are connected to a sump pump or drainage and new concrete is then poured over the system.

framing basement wall with drain pipe - Framing Basement Walls ...
decoryourhouse.com


Exterior waterproofing

Exterior waterproofing prevents water from entering foundation walls therefore preventing the wicking and molding of building materials. Waterproofing a structure from the exterior is the only method the IBC (International Building Code) recognizes as adequate to prevent structural damage caused by water intrusion. Prior to the 1980s much of the original exterior waterproofing was damp-proofing using a degradable asphalt-based covering. Waterproofing an existing basement begins with excavating to the bottom sides of the footings. Once excavated, the walls are then sealed with a waterproofing membrane and new drainage (weeping tiles) are placed at the side of the footing.

Polymer-based compounds

Over the past ten years, polymer-based waterproofing products have been developed. Polymer-based products last for the lifetime of the building, and are not affected by soil pH. Polymer-based waterproofing materials have the advantage of a low enough viscosity that they can be sprayed directly onto a wall, are very fast curing, and are semi-flexible, allowing for some movement of the substrate.

Basement: Design My Basement
basementimagination.blogspot.com


Causes of water seepage and leaks

Water seepage in basement and crawl spaces usually occurs over long periods of time, and can be caused by numerous factors. Oftentimes, water damage may begin as early as the construction process but may be worsened by compounding issues.

  • Concrete is one of the most commonly used materials in home construction. When pockets of air are not removed, or the mixture is not allowed to cure properly the concrete can crack, which allows water to gradually force its way through the wall.
  • Foundation footings are horizontal pads that define the perimeter of foundation walls. When footings are too narrow or are not laid deep enough, they are susceptible to movement caused by soil erosion.
  • Gutters and downspouts are used to catch rain water as it falls, and discharges it away from houses and buildings or into underground storm drains. When gutters are clogged or downspouts are broken rainwater is absorbed by the soil near the foundation, increasing hydrostatic pressure.
  • Subsidence is the downward shifting of soil under or near a structure's foundation caused by water saturation, the removal of groundwater or as an aftereffect of mining.
  • Weeping tile is a porous plastic drain pipe installed around the perimeter of the house. The main purpose of external weeping tile is preventing water from getting into the basement. Internal weeping tile systems redirect water to the sump pump pit. When drain pipes are clogged or damaged excess water puts pressure on internal walls and basement floor.
How do you build a wall? I Finished My Basement
www.ifinishedmybasement.com


Sump pumps

There are various types of sump pump systems used for basement waterproofing. The majority of sump pump systems are submersible. A sump well is installed in the ground and a submersible pump is placed in the bottom of the pit. Once the well fills up with water, a floating mechanism on the pump allows the pump to turn on and the water is discharged.



Warning signs of water damage

Signs that water is seeping into a basement or crawlspace often take years to develop and may not be easily visible. Over time, multiple signs of damage will become evident and could lead to structural failure.

  • Cracked walls: Cracks may be horizontal, vertical, diagonal or stair-stepped. Severe pressure or structural damage is evident by widening cracks.
  • Buckling walls: Usually caused by hydrostatic pressure. Walls appear to be bowed inward.
  • Efflorescence: White, powdery residue found on basement walls near the floor.
  • Mold: Fungi that usually grow in damp, dark areas and can cause respiratory problems after prolonged exposure.


Are You Looking for Products

Here some products related to "Basement Waterproofing".

ESP Low-E® SSR Reflective Foam Core Insulation Kit: Roll Size 16 ...
ESP Low-E® SSR Reflectiv..
Amazon.com - Whynter 12, 000 BTU Dual Hose Portable Air ...
Amazon.com - Whynter 12, ..
RadonSeal® Efflorescence Cleaner (2.5-gal) | The Safe & Easy ...
RadonSeal® Efflorescence..
Amazon.com: Amped Wireless High Power Wireless-N 600mW Smart ...
Amped Wireless High Power..

Get these at Amazon.com

* amzn.to is official short URL for Amazon.com, provided by Bitly

Source of the article : here




2 komentar

avatar

Very helpful recommendations you have shared. For more information visit: Basement Waterproofing

avatar

Each basement and situation is different so it is important to know where the moisture could potentially come in from and to create a comprehensive solution that is going to last.
http://www.thebasementguyscleveland.com/services/basement-waterproofing


EmoticonEmoticon

 

Start typing and press Enter to search